Digital Euro Facial Steamer With Aromatherapy + LED Magnifying Lamp

Features

• Slim compact design
• Movable arm unlimited positioning (You may move the arm to up and down, tilt and to side to side positions)
• Aromatherapy capability cartridge
• Dual heat sensors to prevent from overheating
• Energy adjustment control
• Ozone Capability Note: mode should be used only as directed in a professional, well-ventilated treatment room. Do not use as an air purifier or continuous room deodorizer.
• Quiet operation/no ticking noise

Review the Steamer Caution guide for safety protocols and professional usage requirements:
Steamer Caution

• Heights from ground to top of steamer: 31" - 42"
• Steamer arm length: 24"
• Lamp lens diameter: 4.5"
• Magnifying lamp diameter: 9"
• Base diameter: 27" 
• Power Consumption: 750 W
• Frequency: 50-60 Hz

 Disclaimer - Steamer Caution

For Professional Use Only. All products are made to be used by Trained Professionals in a Professional environment only. Do not leave client unattended with steamer.

It is important to operate any equipment safely to avoid potential dangers. As the operator, it is your responsibility to ensure the safe operation of this equipment. Please carefully read and follow all warnings, safety signs, and instructions provided with or attached to the equipment. It is crucial not to remove, disable, deface, or render any of the safety devices or warnings on this equipment inoperable. If any safety devices or warnings have been tampered with, do not use this equipment!

For this 120-volt equipment, make sure to use a grounded outlet and do not modify the plug. Always wear appropriate safety attire, including eye protection and rubber insulated gloves.

1. Check the steamer to ensure it is empty of water. If not, empty all water.
2. Add one gallon of water, preferably distilled water. Securely replace the fill cap, but do not over-tighten. (The steamer will produce steam for approximately one hour with one gallon of water.)
3. Plug the steamer into a 120-volt, 15-amp grounded outlet. Do not use an extension cord. Place the steam pan into a clean bucket or paint pan until the steamer reaches the desired temperature and starts producing steam (approximately 15 to 20 minutes).
4. After approximately one hour of steaming, check the water level gauge. Unplug the steamer and remove the fill cap. Replenish the water to the proper level. Exercise caution when removing the cap from a steamer that has been in use, as hot steam may escape from the fill pipe. Use warm water and never pour cold water into a hot steamer.
5. Do not let the steamer run out of water. If it does, unplug it and allow approximately 15 minutes for it to cool down. After the steamer has cooled down, refill it with water and press the reset button located inside the finger hole on the service door. Never pour cold water into a hot steamer.

It is essential to allow the steamer to cool down completely before draining and returning it to the rental facility. If there are any concerns about the operation or safety of the equipment, do not use it! Instead, contact customer service for assistance. Failure to follow these instructions may lead to potential injury.