Malibu Electric Medical Spa Treatment Table (Facial Chair/Bed)

Movements

• Electric backrest angle adjustment
• Electric leg rest angle adjustment
• Electric height adjustment
• Electric seat tilt adjustment
• Manual chair rotation
• Manual removable armrests
• Manual headrest extension
• Manual leg rest extension

Dimensions/Specifications

• Length with leg rest extension and headrest attached: 73"
• Length with both leg rest extension and head rest extended out: 83"
• Width without armrests: 23"
• Width with armrests: 33"
• Heights: 25" - 37"
• BASE ONLY Dimensions: 40" L x 31" W
• Backrest angle: 0° to 80° incline
• Leg rest angle: 0° to 85° decline
• Seat tilt angle: 0° to 10°
• Rotation: 0° to 240°
• Capacity of 350 lbs.
• Colors available: Black, White, Camel Orange, Gray, Wine, Papaya, and Light Sapphire
• Fully electric except for rotation
• Buttons on back of chair itself control the motors
• Reset button makes the chair fully upright and at the lowest height
• Three sections
• Breather hole
• 50-60 Hz
• 200 W
• Voltage: 100-120 V
• Power: 2 amp

* All measurements have a 0.25 to 1.2-inch tolerance

Download Manual

Disclaimer

When operating a hydraulic or electric rotating facial bed or treatment table, it is the operator’s responsibility to ensure the safety of their clients.

To ensure stability

1. Be sure bed is on a level, non-slippery surface.
2. Be sure to adjust self-leveling feet.
3. Always orient the bed in-line or parallel with the base for treatment purposes.
4. When rotating the bed, it is recommended that there be no client on the bed at that time.
5. If there is a client on the bed during rotation, it is recommended that client be seated in the upright sitting position.
6. When rotating the bed, if there is a client in the bed, the bed MUST be held from underneath at the head of the bed by the operator as it is in rotation.
7. Sitting on either the head or the foot of the bed is strictly forbidden, regardless of the position of the bed.
8. Hydraulic or electric rotating facial beds or treatment tables are not designed for massage. Excess downward pressure can cause instability.
9. Aligning the bed perpendicular to the base or using the bed on a slippery surface may cause the bed to become unstable. Injury to patron may occur.